Setting
Description
Transmission time
Controls the time between transmitted loop protection packets
Note
• The default transmission time is 5 seconds.
• The value must be from 1 to 10 seconds.
Shutdown time
Controls how long to disable a port after detecting a loop
Note
• The default shutdown time is 180 seconds.
• The value must be from 0 to 604800 seconds.
5. Click Apply.
QSS or QuNetSwitch saves the settings.
Deleting a Network Setting
1. Log in to QSS, or open QuNetSwitch in QTS.
2. Go to Configuration.
3. Select a network setting.
Note
Deleting network settings is applicable only to link aggregation groups, static MAC addresses,
and VLANs.
4. Click .
A confirmation message appears.
5. Click Delete.
Monitoring Network Settings
You can monitor the following network settings in the Configuration section. These settings can be used to
monitor and diagnose switch operations.
1. Log in to QSS, or open QuNetSwitch in QTS.
2. Go to Configuration.
3. Select a network setting.
Setting
Description
IGMP Snooping
Statistics
Go to IGMP > IGMP Snooping Statistics .
Displays statistical information about detected IGMP groups.
LLP Remote Devices
Go to LLDP > LLDP Remote Devices .
Displays information about the LLDP-enabled port including system
capabilities and remote management IP address.
QGD Rackmount Switch User Guide
Switch Management
70
