QMS Magicolor, User Manual

Page: 383 / 446

FCC Compliance
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at
his own expense.
To comply with part 15 of FCC rules, shielded interface cables must be used.
WARNING!
To prevent electrical shock, do not remove any covers from
your printer unless you are experienced in working with circuit boards and
are following instructions for procedures described in QMS documentation.
ACHTUNG!
Um einen Elektroschock zu vermeiden, sollte die Drucker-
abdeckung niemals von Unbefugten geöffnet werden. In jedem Fall müssen
die diesbezüglichen Hinweise des Handbuches genau beachtet werden!
CAUTION:
Any modifications or changes to this product not expressly
approved in writing by the manufacturer responsible for compliance to Federal
Regulations could void the user’s authority to operate this product within the Laws
and Regulations of the Federal Communications Commission.
Canadian Users
This digital apparatus does not exceed the Class A limits for radio noise emissions
from digital apparatus set out in the Radio Interference Regulations of the
Canadian Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les
limites applicables aux appareils numériques (de la classe A) prescrites dans le
Règlement sur le brouillage radioélectrique édicté par le ministère des
Communications du Canada.
Appendix C
N o t i c e s C - 1