QMS Magicolor, User Manual

Page: 323 / 446

Introduction
This chapter explains how to deal with control panel messages,
remove jams, cancel jobs, and troubleshoot printer problems.
Responding to Status Messages
The following status messages may appear in the control panel
message window:
x ACTIVE
JOBS The printer is on line, and one or more jobs are in
progress. The x is replaced by the number of jobs in the
queue.
ADJUST
xxxxx BIN A media cassette is either not installed or installed
incorrectly. The xxxxx indicates the cassette in
question. Either install or reinstall the indicated
cassette.
BACK PANEL
OPEN The back cover over the transfer unit is not fully closed.
Close the back cover.
BELT
CARTRIDGE
MIS-
INSTALLED The OPC belt cartridge is either not installed or
incorrectly installed. Either install a cartridge if one is
not present or reinstall the current one correctly. (See
c ha p te r 6 , “Co nsu mabl es a nd Pr eve nta tiv e
Maintenance,” for information on replacing the OPC
belt cartridge.)
CANCELLING
JOB The Cancel key has been used to cancel the current job.
This message is displayed until the job is cancelled.
CHECK
WASTE
TONER The waste toner pack is full and needs to be replaced.
See “Replacing the Waste Toner Pack” in chapter 6 for
details.
CLOSE
MANUAL
FEED TRAY The manual feed tray is open when a file is being sent
to print from another cassette. Close the manual feed
tray.
x DEV LOW A developer cartridge is running low and needs to be
replaced. The x is replaced by the color of the developer
Chapter 9
T r o u b l e s h o o t i n g 9 - 1