QMS Magicolor, User Manual

Page: 290 / 446

port; then connect the box to a power cord and plug the power
cord into an electrical outlet.
Using an Optional Network Interface
After you have correctly installed an optional network interface,
refer to the following for more information:
■ The “Administration/Communications/Serial” section of
chapter 4, “Printer Configuration,” contains information
about the PS Protocol option in the new optional network
interface submenu that appears in the Administration/
Communications menu.
■
The manual that comes with the optional network interface
contains information about all other options in the new
network interface submenu, as well as instructions for
connecting the printer to the network and for printing over
the network.
■ Your network documentation also contains information on
printing over the network.
Centronics to Dataproducts Conversion
Your printer is shipped with a Centronics parallel port, but a kit for
converting it to Dataproducts is available from your QMS vendor.
Make sure you have all the parts necessary for the conversion. The
Dataproducts conversion kit includes the following:
■ An anti-static wristband
■ Two 2-pin shunts (small plastic pieces lined with metal)
■
Two DIP resistors (a 220 ohm and a 330 ohm)
Chapter 8
8 - 3 2 P r i n t e r O p t i o n s