QMS Magicolor 2 plus, Manual

Page: 48 / 90

-#*
9 At the
ftp>
prompt, end the ftp session by typing
quit
↵
10 When the Disk light stops flashing and the printer’s message window reads
Idle
for at least 30 seconds, turn the printer off and then on again.
11 When the printer’s message window reads
Idle
again, the fonts are ready
to use.
The fonts should be listed in the Options section of the printer’s startup page, in
the Administration/PCL 5E printer’s configuration menu, and on the advanced sta-
tus page.
» Note: You may want to erase any installation files left on your computer (and/or
workstation), and then remove any temporary directories.
CID fonts are supported on the magicolor 2+. CID fonts are a format of composite
(multibyte) Type 1 fonts that address the requirements of Far East markets. CID-keyed
refers to the character identifier (CID) numbers that are used to index and access the
characters in the font. A CID font consists of a large font file that contains all the char-
acter outlines and a small CMap file that contains a list of characters, encodings, and
character identifiers. Each CID font can support many character set and encoding
combinations.
23$1
The preformatted QMS Kanji font internal IDE hard disk contains Kanji fonts and other
files. These fonts can be printed at a variety of point sizes and in different styles and
resolutions.
After the Kanji hard disk is installed in your QMS magicolor 2+, the Kanji fonts are
available for use just as if they were resident in the printer.