QMS Magicolor 2 plus, Manual

Page: 45 / 90

$+
'( )* ) %
9 At the
ftp>
prompt, end the ftp session by typing
quit
↵
10 When the Disk light stops flashing and the printer’s message window reads
Idle
for at least 30 seconds, turn the printer off and then on again.
11 When the printer’s message window reads
Idle
again, the emulation is
ready to use.
The emulation should be listed in the Options section of the printer’s startup page,
in the Administration/Emulation printer’s configuration menu, and on the advanced
status page.
» Note: You may want to erase any installation files left on your computer (and/or
workstation), and then remove any temporary directories.
' %&
Use the Administration/Emulation menu to set the parameters for the available printer
emulations. Optional emulations appear only if installed.
Refer to the documentation that came with your emulation for configuration and usage
instructions.
» Note: To choose an emulation for a particular interface, use the appropriate interface
menu in the Administration/Communications menu.
The QMS ImageServer option includes products that raise image printing perfor-
mance and enhance print functionality to a level comparable to that of the document
imaging system as a whole. Typically, print performance in a non-ImageServer envi-
ronment is realtively slow due to the nature of raster file formats and the lack of atten-
tion given to print system enabling within the imaging system.
ImageServer option products specifically address these limitations and adapt QMS
printer products to the document imaging system. Optional emulations such as the
QMS ImageServer are available as PostScript files on floppy disks for your computer.
When an emulation has been downloaded for the printer’s hard disk and the printer
has been rebooted, the emulation will show up on the printer status page and the con-