QMS Crownnet, Setup Manual

Page: 36 / 86

Interface
Configuration
QMS CrownNet Setup Guide 34
NetWare Interface Configuration (Netware 3.x)
Unless you want to use the default settings, use the following proce-
dure to name the file and print servers. These names must be unique.
» Note: In CrownAdmin 3, the printer shows up as
QMS_xxxx_Print_
System_hardwareaddress
, where
xxxx
is the printer model
number and
hardwareaddress
is the printer’s hardware address as
found on the printer start-up page. This address will be blank until the
interface has been reset following installation.
1 In the Administration/Communications/ xxxxxxxx NIC/Crown-
Net/NetWare/Config PServer/File Srv Name[1], File Srv
Name[2], and File Srv Name[3] menus, (where
xxxxxxxx is
either Resident or Optional) enter the name of the target file
server (primary 3.
x configuration server).
» Note: The three File Srv Name[x] menus allow you to identify 1
file server with a name up to 47 characters long. (Up to 16
characters can be entered in the first two menus and 15 in the
third menu). You cannot use these 3 menus to identify 3 file
servers. Up to 16 file servers are supported. To enter the 15 other
file server names, use CrownAdmin 3.
Spaces and lowercase characters are not allowed within file
server names. However, underscore characters (_) are allowed
to simulate multiword names (for example, PUBS_SERVER). At
the printer control panel only, a space must be used following the
last character of the file server name to end the name. For
example, the file server name
FIRSTGROUP_GROUPS_BLUE_TEAM_TEAMS_CRC_QMS
is 42 characters long, and must be entered as follows:
FILE SRV NAME[1]
FIRST_GROUP_GROU
File Srv Name[2]
PS_BLUE_TEAM_TEA
File Srv Name[3]
MS_CRC_QMS<space>
where <space> is the space character.