QMS CF 2215, User Manual

Page: 16 / 50

Getting Started
QMS MAGNUM Emulation User's Guide 2-2
Getting Started
The following major steps are involved in setting up and using the
QMS MAGNUM emulation:
n
Adding additional memory (if necessary)
n
Configuring printer memory
n
Using the emulation
Adding Additional Memory
The QMS MAGNUM emulation requires 2 MB of memory for optimal
emulation download and performance. When you have only the stan-
dard memory on your QMS Crown printer, that memory has been
configured at the factory, and any excess has either been allocated to
the display list or frame buffer, or it has been distributed among all cli-
ents (depending on which printer you have). QMS recommends the
following for your printer:
For this
printer... You need to...
QMS 1060E/
1660E Add 4 MB of additional RAM. See chapter 6, “Printer
Options,” in your printer
Reference guide for information
on installing additional memory. After the memory is
installed, refer to the “Configuring Printer Memory”
section, later in this chapter, for information on changing
the K Mem Emulation memory setting.
» Note: Remember that an optional hard disk is
required to download the MAGNUM emulation.