QMS 860, User Manual, Page: 107 / 398

Spool Timeout (5 digits; default 00030; range 00000-99999)
Maximum number of seconds the interface waits for
data from the host system before terminating a spooled
print job.
End Job Mode (default none; range none, QMS EOD, HP EOD)
Sequences that allow host computers to enforce print
job sequencing without considerations for interacting
timeouts. Enables or disables data stream sensing for
the end-of-document (EOD) command. See appendix
F, “Additional Technical Information,” for details on
how to implement this feature on your QMS 860 Print
System.
None PostScript ^D (CTRL D) command
QMS EOD %%EndOfDocument
HP EOD <ESC>%-12345X
Baud Rate (default 9600; range 300, 600, 1200, 2400, 4800, 9600,
19200, 38400)
Rate that data is transmitted (bits per second) over the
serial interface.
Parity (default none; range none, mark, space, odd, even)
Check bit used to identify data transmission errors. The
printer’s parity setting must match the host computer’s
or application’s parity setting.
Ignore Parity (default off; range on, off)
On ignores parity
Off does not ignore parity
Rcv Sw
Flow Ctl (default XON/XOFF; range XON/XOFF, ETX/ACK,
none)
Software communication protocol used by the printer
to control communication from the host computer.
Xmit Sw
Flow Ctl (default none; range none, XON/XOFF, ETX/ACK)
Software communication protocol used by the printer
to control communication with the host computer.
Data Bits (default 8 bits; range 8 bits, 7 bits)
Number of data bits transmitted per character.
Chapter 4
P r i n t e r C o n f i g u r a t i o n 4 - 2 7