QMS 2425, Getting Started

Page: 90 / 144

&RQILJXUHWKH
,QWHUIDFH
406785%23ULQW6\VWHP*HWWLQJ6WDUWHG
&RQILJXUHWKH,QWHUIDFH
This section briefly describes the configuration procedure for the
printer interface. For a complete discussion of all of the configuration
options available through the Administration/Communications/Net-
work
x/CrownNet menu, see chapter 2, “Interface Configuration,” of
the QMS CrownNet System Administrator’s Guide.
You can make these configuration changes through any of the follow-
ing means:
„
Printer Control Panel—For information on using the printer con-
trol panel to change configuration menu settings, refer to chapter
4, “Printer Configuration,” of the
Reference manual.
„
CrownAdmin (for DOS and Macintosh 3), CrownAdmin 3 (for
AIX, HP-UX, Solaris/SunOS, and Windows/Windows NT/Win-
dows for Workgroups), or CrownNet Manager (for OS/2)—For
more information on using this software, refer to the appropriate
chapter in the
QMS CrownNet System Administrator’s Guide or to
the software’s on-line help.
„
Remote Console—For information on accessing Remote Con-
sole, refer to the appropriate chapter in the
QMS CrownNet Sys-
tem Administrator’s Guide. For information on using Remote
Console, refer to the
QMS Crown Remote Console User’s Guide.
(WKHU7DON,QWHUIDFH&RQILJXUDWLRQ
1 If your network has more than one zone, use the Administra-
tion/Communications/Network
x/CrownNet/EtherTalk/Zone
Name/Zone Part 1 and Zone Part 2 menus to enter the name
of the zone to which the printer is attached.
» Note: The two Zone Part x menus allow you to identify 1 zone
with a name up to 32 characters long. (Up to 16 characters can
be entered in each of the two menus). You cannot use these two
menus to identify two zones. Trailing spaces are not considered
part of the zone name. All standard printable ASCII characters
are valid except the @ and ' symbols. The names are case
sensitive.