QMS 2060, Supplementary Manual

Page: 27 / 160

8SGDWLQJ
6\VWHP
6RIWZDUH
0HPRU\DQG6\VWHP6RIWZDUH
3URFHGXUH
—
3&8VHUV
—
3DUDOOHODQG6HULDO
Use the following procedure to update the system software in flash
memory whether downloading through the parallel or serial port.
'HFRPSUHVVLQJWKH6\VWHP6RIWZDUH
Before the printer system software can be downloaded, it must be
decompressed on your PC’s hard disk.
1 Switch to an MS-DOS prompt.
1 Create a new directory on your PC.
2 Change to this directory.
3 Insert the printer system software disk in your PC’s 3.5" disk
drive.
4 Type
x:pkunzip x:system.zip
↵
where x is the name of
the disk drive in which you inserted the system software
disk.
5 Follow the prompts.
They instruct you to insert the system software disks in the follow-
ing order:
a Last disk (system software disk 3)
b Disk 1 (system software disk 1)
c Disk 2 (system software disk 2)
d Disk 3 (system software disk 3)
6 Turn on the printer, wait for
IDLE
to appear in the message
window, and then print an advanced status page.
The advanced status page provides a record of all current config-
uration settings, so you can verify that they are the same or
recover your settings after the system software has been
updated.