QMS 1725E, Reference

Page: 186 / 288

Kanji Fonts
QMS 1725E Print System Reference 6-56
has an optional Kanji hard disk installed, the Kanji fonts are available
for use just as if they were resident in the printer.
Hardware Requirements
To use your QMS Kanji fonts, you need
n A QMS Kanji Option Kit
n Minimum of 12 MB memory
n A Macintosh, IBM PC, or compatible computer with a Kanji
operating system and a Kanji application.
» Note: Your printer can’t support Kanji with the standard memory; you
must add an additional 4 MB of memory to the printer for Kanji
support. This additional memory will also increase speed because
additional memory is allocated to font caching.
Installing the Kanji Disk
The following instruction for installing an external Kanji disk
describes the general steps for installation. Refer to QMS Crown
Kanji Option Installation Instructions, which accompanies the
Kanji kit for detailed instruction.
O Caution: The Japanese fonts are factory installed on a formatted hard
disk drive. DO NOT reformat or initialize the QMS Kanji hard disk drive.
Reformatting this drive erases all data, fonts, and files on the disk. The
QMS Crown Kanji Option Kit warranty does not cover this error.
1 Turn off the printer’s front and rear power switches.
2 Lift the Kanji hard disk drive out of its shipping container,
place it on a level surface, and remove any packing material.
3 Assign a unique SCSI device number.
Multiple disks may be attached in a daisy chain. Each hard disk in
the chain has a device number. The device number identifies
each hard disk (in the range 0 to 6), and assigns a drive priority
on the chain, with 6 representing the highest priority. Do not use