QMS 1725E, Getting Started Manual

Page: 62 / 94

Configuring the Interface
QMS 1725E Print System Getting Started 4-10
Configuring the Interface
This section describes the quick configuration procedure for the
printer interface. For a complete discussion of all of the configuration
options available through the Administration/Communications/Crown-
Net menu, see chapter 2, “Interface Configuration,” of the
QMS
CrownNet Interface System Administrator’s Guide
.
You can make these configuration changes through any of the follow-
ing means:
n
Printer Control Panel—For information on using the printer con-
trol panel to change configuration menu settings, refer to chapter
4, “Printer Configuration,” of the
Reference
guide.
n
CrownAdmin (for DOS, Macintosh System, or Windows) or
CrownNet Manager for OS/2—For more information on using
this software, refer to the appropriate chapter in the system
administrator’s guide.
» Note: CrownAdmin/CrownNet software is not available for the UNIX
environment.
n
Remote Console—For information on accessing Remote Con-
sole, refer to the appropriate chapter in the system administra-
tor’s guide. For information on using Remote Console, refer to the
QMS Crown Remote Console User’s Guide
.
EtherTalk
1 If your network has more than one zone, use the Administra-
tion/Communications/Network 2/CrownNet/EtherTalk/Zone
Name/Zone Part 1 and Zone Part 2 menus to enter the name
of the zone to which the printer is attached.
» Note: The two Zone Part x menus allow you to identify 1 zone with a
name up to 32 characters long. (Up to 16 characters can be entered in
each of the two menus). You cannot use these two menus to identify
two zones. Trailing spaces are not considered part of the zone name. All
standard printable ASCII characters are valid except the @ and '
symbols.