QMS 1725E, Getting Started Manual

Page: 37 / 94

Printing a Start-up Page
2-13 Setting Up Your Printer
2 Press the front power switch located on the front, right side
of the printer.
» Note: The Ready light flashes as the printer warms up, and then the
message display flashes several messages. After a brief warm-up time,
approximately 90 seconds, the printer produces a start-up page.
Printing a Start-up Page
When you turn on the printer, a start-up page prints. This page gives
you an overview of your QMS 1725E Print System.
The following information prints on the start-up page:
n
Printer product name
n
Cumulative number of printed sheets
n
Amount of resident RAM (in bytes)
n
Number of PostScript typefaces in ROM
n
Default resolution
n
Software version, revision, and release numbers
n
Firmware level number
n
Address and status (on or off line) of attached hard disk(s), if any
n
Emulation and protocol information of all standard and optional
interfaces
If the start-up page prints with all the start-up page information, and
the print quality is good, you may install any optional hardware you