QMS 1725E, Getting Started Manual

Page: 30 / 94

Removing Packing Materials
QMS 1725E Print System Getting Started 2-6
1 Pull the top cover release button (located on top of the
printer opposite the control panel) forward to open the
printer top section.
2 Locate the two spacers with orange tags.
One is on each side of the fuser assembly.
3 Grasp the spacers and gently pull them out from under the
fuser assembly.
4 Check inside the printer to make sure there are no other
packing materials.
Removing Paper from the Transfer Charge
Roller
O Caution: Make sure you leave this sheet of paper in place until the spacers
have been removed. Permanent damage to the roller could result if any
contaminants get on the roller.