Configuring the
Interface
4-13
Connecting to an Ethernet Network
the printer control panel only, a space must be used following the
last character of the print server name to end the name.
3
In the Administration/Communications/Network 2/CrownNet/
NetWare/RN Printer/Printer Slot # menu, enter the printer slot
number.
»
Note:
This number must match the slot number chosen in the
Printer Configuration submenu of the Print Server Configuration
menu in the NetWare PCONSOLE utility.
4
In the Administration/Communications/Network 2/CrownNet/
NetWare/RN Printer/PServer Name[1], PServer Name[2], and
PServer Name[3] menus, enter the name of the print server.
»
Note:
The three PServer Name[x] menus allow you to identify 1
print server with a name up to 48 characters long. (Up to 16
characters can be entered in each of the three menus). You
cannot use these
three menus to identify three print servers.
Spaces and lowercase characters are not allowed. However,
underscore characters (_) are allowed to simulate multiword
names (for example, PUBS_PSERVER). At the printer control
panel only, a space must be used following the last character of
the print server name to end the name.
5
Reset the NIC by using the Administration/Communications/
Network 2/CrownNet/Common/Soft Reset menu.
6
Go to the next section, “Configuring the Network.”
TCP/IP
1
/If necessary, in the Administration/Communications/Net-
work 2/CrownNet/TCPIP/Internet Address menu, enter the
printer’s Internet address.
The factory default Internet address is 161.033.128.024.
2
If necessary, in the Administration/Communications/
Network 2/CrownNet/TCPIP/Default Router menu enter the
Internet address of the default router.
The factory default router address is 000.000.000.000.
Summary of Contents for 1660E
