QMS 1660E, Getting Started

Page: 65 / 114

Configuring the
Interface
4-11 Connecting to an Ethernet Network
n
CrownAdmin (for DOS, Macintosh System, or Windows) or
CrownNet Manager for OS/2—For more information on using
this software, refer to the appropriate chapter in the system
administrator’s guide.
» Note: CrownAdmin/CrownNet software is not available for the
UNIX environment.
n
Remote Console—For information on accessing Remote Con-
sole, refer to the appropriate chapter in the system administra-
tor’s guide. For information on using Remote Console, refer to the
QMS Crown Remote Console User’s Guide .
EtherTalk
1 If your network has more than one zone, use the Administra-
tion/Communications/Network 2/CrownNet/EtherTalk/Zone
Name/Zone Part 1 and Zone Part 2 menus to enter the name
of the zone to which the printer is attached.
» Note: The two Zone Part x menus allow you to identify 1 zone
with a name up to 32 characters long. (Up to 16 characters can
be entered in each of the two menus). You cannot use these two
menus to identify two zones.
All standard printable ASCII characters are valid except the @
and ' symbols. Trailing spaces are not considered part of the
zone name.
2 Go to the next section, “Configuring the Network.”
LAN Manager/LAN Server
1 One unique printer name is broadcast to the network. Use
the Administration/Communications/Network 2/CrownNet/
Lan Manager/Printer Name menu to enter the name of the
printer.
» Note:
The name can be up to 16 characters long. Spaces and
lowercase characters are not allowed. However, Underscore
characters (_) are allowed to simulate multiword names (for
example, PRODUCT_MKTG).