QMS 1060, User Manual

Page: 191 / 311

Kanji Option
Kit
6-25 Printer Options
» Note: Before installing this kit, you must have an optional IDE-SCSI
board. The optional IDE-SCSI (Integrated Drive Electronics-Small
Computer System Interface) board supports the Kanji internal IDE
hard disk and up to three external SCSI hard disks.
Installing IDE-SCSI Board and IDE Hard Disk
For this installation, the controller board is removed and the Kanji
internal IDE hard disk is mounted on an IDE-SCSI board. Then they
are both installed in the printer. The “IDE-SCSI Board” section, later in
this chapter, contains the detailed steps for installing the board. This
procedure refers you to other procedures, when necessary, for install-
ing the IDE hard disk.
Configuring the Printer for Kanji
You need to reconfigure the printer’s memory in order to access the
Kanji fonts. The instructions for reconfiguring the memory comes in
your Kanji Option Kit. See the “Configuring the Printer” section of
those instructions, for details on modifying the minimum Kanji mem-
ory settings listed in the following section.
Minimum Kanji Memory Settings
Memory Client Minimum Kanji Setting
K Mem for Spool 112
K Mem for PSHeap 3584
K Mem for PS Fonts 496
K Mem Emulation 768
K Mem Emul Temp 256
K Mem Display 512
K Mem Disk Cache 256
Accessing the Kanji Fonts
Follow the instructions in the “Accessing the Kanji Fonts” section of
the documentation that comes with the Kanji Option Kit.