QBASIC PLUS
INSTALLATION INSTRUCTIONS
IMPORTANT
Read and understand all instructions before installing.
INSTALL THE MOUNTING BRACKETS
If the clutch is on the right end of the shade, attach the brackets to the window frame, window molding, wall or ceiling, as shown below.
If the clutch is on the left end of the shade, reverse the bracket positions, left for right.
1. The brackets are configured for mounting based on the original order.
However, if a change is needed, you can adjust the spring bracket.
•
Adjusting the Spring Bracket
– Remove the three phillips head screws
which attach the inner mount to the outer bracket. If changing from back or
side mount to top mount, rotate the outer bracket so that the bracket holes
are at the top, the stop is to the back and the opening for the plug slot is at
the front. Reattach the inner mount to the outer bracket.
NOTE:
The clutch bracket does not need to be adjusted.
2. Mark the spots in the wall or window sill where the screws will be located. Drill
a pilot hole with a 1/8” drill bit.
3. Using a hex driving bit, install the screws as shown below. Make sure that the
brackets are level.
Clutch Bracket
Spring Bracket
Screws
Inner Mount
Outer Bracket
Back or Side Mount
Configuration
Top Mount
Configuration
Stop
Opening for
Plug Slot
Rotating the Plug Bracket for Top Mounting
Clutch Bracket
Spring Bracket
Spring
Bracket
Clutch
Bracket
Back Mount
Side Mount
Top Mount
Spring Shaft
Clutch
Spring
Bracket
Clutch
Bracket
Control
Chain
Tab
Child Safety
Bracket
INSTALLING THE SHADE
1. With the shade still wrapped in plastic but with the ends exposed, insert the tab on the
clutch bracket into the clutch, then swing the plug end into the slot, so that it rests at the
bottom of the slot.
2. Remove plastic covering.
Spring
Shaft
Rests
Here
Spring
Shaft
