Qlogic SANbox 5800V Series, Installation Manual

Page: 82 / 134

3–Installation
Installing a Switch
3-12 59265-02 B
Configure the Switch
You can configure the switch using the CLI, QuickTools, or Enterprise Fabric
Suite. Enterprise Fabric Suite is an optional, full fabric graphical user interface that
comes with a 30-day trial license. For information about installing Enterprise
Fabric Suite, refer to the
QLogic 5800V Series Enterprise Fabric Suite User’s
Guide .
QuickTools Switch Configuration
To log in and configure the switch using QuickTools:
1. Open an Internet browser, and then type the default IP address 10.0.0.1 to
start the QuickTools Web applet.
2. Log in to the switch using the default user name ( admin ) and password
( password ).
3. Obtain the IP address and subnet mask from your network administrator.
4. Open the QuickTools Wizards menu and select Configuration Wizard .
Follow the instructions to set the switch IP address and the password.
Changing the IP address will terminate the QuickTools session.
5. Open an Internet browser again and log in with the new IP address.
CLI Switch Configuration
To configure the switch using the CLI:
1. Open a command window according to the type of workstation and
connection:

Ethernet (all platforms): Open a Telnet session with the default switch
IP address, and then log in to the switch with default account name
(
admin ) and password ( password ). For example:
telnet 10.0.0.1
Switch Login: admin
Password: *******
NOTE:
To insure user account security, change the password for the
Admin account name. Refer to the Passwd command in the
QLogic 5800V Series Fibre Channel Switch Command Line
Interface Guide
.