Qlogic SANbox 5800V Series, Installation Manual

Page: 105 / 134

4–Diagnostics/Troubleshooting
Recovering a Switch Using Maintenance Mode
59265-02 B 4-15
5. Select option 1 from the maintenance menu. When prompted for a file name,
type the firmware image file name. For example:
Image filename: filename
Unpacking ’filename’, please wait...
Unpackage successful.
6. Select option 7 to reset the switch and exit maintenance mode.
Resetting the Network Configuration in Maintenance Mode
(Option 2)
The Reset Network Config option resets the network properties to the factory
default values, and saves them on the switch. For information about the default
network configuration values, refer to the
QLogic 5800V Series Fibre Channel
Switch Command Line Interface Guide .
Resetting User Accounts in Maintenance Mode (Option 3)
The Reset User Accounts to Default option restores the password for the Admin
account name to the default (password), and removes all other user accounts
from the switch.
Copying Log Files in Maintenance Mode (Option 4)
The Copy Log Files option copies all log file buffers to a file on the switch named
logfile . You can use FTP to download this file to the management workstation;
however, you must download the logfile before resetting the switch. For
information about downloading files from the switch, refer to the QLogic 5800V
Series Fibre Channel Switch Command Line Interface Guide .
Removing the Switch Configuration in Maintenance Mode
(Option 5)
The Remove Switch Config option deletes all configurations from the switch,
except the default configuration. This option restores switch configuration
parameters to the factory defaults. For information about the factory default
values, refer to Reset command in the
QLogic 5800V Series Fibre Channel
Switch Command Line Interface Guide .