Qlogic QConvergeConsole CLI 2400 Series, User Manual

Page: 80 / 366

5–Fibre Channel Noninteractive Commands
-fg (Show Driver Settings)
5-12 SN0054667-00 C
3. Issue the
qaucli -pr fc
command with the
-f
option (input from
command file):
# qaucli -pr fc -f setadapter0.txt
# qaucli -pr fc -f < file name >
QConvergeConsole CLI specifies command line input from file.
-fg
(Show Driver Settings)
To show the driver settings, issue the following command:
# qaucli -pr fc -fg (< hba instance > | < hba wwpn >) (view | info)
Where:
-fs
(Configure Driver Settings)
Type the following command to configure the driver settings:
# qaucli -pr fc -fs (< hba instance > | < hba wwpn >) {(< param name > |
< param alias >) < param value >}
Where:
The pairs < param name > < param value > and < param alias > < param value > can
be repeated to set multiple parameters in a single command.
Table 5-4 lists the driver configuration parameter names and aliases.
NOTE:
Th e
-fg
option is valid only in noninteractive mode.
The
-fg
option is not supported for Linux/Solaris.
hba instance = Adapter number (use
-g
command to find)
hba wwpn = World wide port name of the adapter
hba instance = Adapter instance number of an adapter port (use
-g
command to find)
hba wwpn = World wide port name of the adapter
param name = Name of the parameters
param alias = Alias of the parameters
param value = New value of the parameters