Qlogic InfiniPath, Install Manual

Page: 27 / 74

2 – Hardware Installation
Hardware Installation
IB0056101-00 C 2-11
Q
Figure 2-5. Assembled QLE7140 with Riser
14. Secure the face plate to the chassis. The InfiniPath adapter has a screw hole
on the side of the face plate which can be attached to the chassis with a retention
screw. The securing method may vary depending upon the chassis
manufacturer. Refer to the system documentation for information about
mounting details such as mounting holes, screws to secure the card, or other
brackets.
The InfiniPath QLE7140 with PCIe riser card is now installed. Next, install the cables
as described in
section 2.6 Then test your installation by powering up and verifying
link status. See section 2.7 .
2.4.3
Hardware Installation for QHT7140 with HTX Riser
Most installations will be in 1U and 2U chassis, using the HTX riser card. This results
in a horizontal installation of the QHT7140. This type of installation will be described
first. Installation in a 3U chassis will be described in the next section.
Installation of InfiniPath QHT7140 in 1U or 2U chassis requires installation with an
HTX riser card.
NOTE: The illustrations in this section are shown for the Full Height Short form
factor. Installation of the HTX Low Profile form factor will follow the same
steps.
To install the InfiniPath adapter with an HTX riser card:
1. The BIOS should be already be configured properly by the motherboard
manufacturer. However if any additional BIOS configuration is required, it will