Qimarox Securyfence, Assembly Instructions Manual

Page: 4 / 73

Assembly instructions Securyfence
4
1 General
This chapter provides general information about the Securyfence and these assembly instructions.
Corresponding documentation
Document Reference
Manual UM-SECURYFENCE_V1.0-EN
Assembly instructions AI-SECURYFENCE_V2.0-EN
OEM parts of fencing
 Safety switch
Manuals of the fencing and OEM parts can be found at www.securyfence.com .
Intended use
The Securyfence components are to be used exclusively as fencing to prevent access to (dangerous)
zones or areas. Securyfence does not provide protection to heat, radiation, sound or any other danger
that can pass under, over or through the mesh of the fencing. Refer to the user manual for more
information. The stability of the fencing depends on the chosen layout. Any additional stability can be
achieved by supports to the wall, ceiling or other constructions.
Liability
Qimarox is not liable for unsafe situations, accidents and damage resulting from ignoring the instruction
in this manual and warnings in the user manual.
CE Declaration of Conformity
Components of Securyfence are conform the Machinery Directive 2006/42/EC. The declaration of
conformity is included in the user manual.
Relevant harmonised standards
The fencing of appropriate height must be placed at the appropriate distance to comply with the
Machinery Directive. Depending on the application, it may be required to install an interlock or a
interlock with guard locking on a door. Refer to the user manual for the relevant harmonised standards.
Observe local laws and regulations for additional standards and requirements.
Manufacturer
Qimarox B.V.
Nobelstraat 43
3846 CE Harderwijk
The Netherlands
Tel:+31 341 436 700
Fax:+31 341 436 701
E-mail: info@qimarox.com
Internet: www.qimarox.com