Qimarox PRORUNNER Mk5, User Manual

Page: 106 / 202

Maintenance driven roller conveyor
106 UM-PRORUNNER_Mk5-1.2-EN-US
12.3 Cleaning
1. Switch off the machine.
2. Secure the main power supply switch with a padlock.
3. Remove deposit and dirt by hand.
4. Report any damage to the technically responsible person or to Qimarox and make
sure that any damage is remedied before restarting the machine.
12.4 Lubrication
12.4.1 Lubricate the drive pulley bearings
1. Lubricate the bearings with an appropriate chain lubricating agent. Qimarox
recommends the following product: Bel Ray No-Tox Food Grade (#64060 / 64070).
12.5 Check the slack on the drive pulley bearings
1. Replace the drive pulley bearings when the bearings produce abnormal noise or
vibration.
12.6 Check the slack on the tension wheel bearings
1. Replace the tension wheel bearings when the bearings produce abnormal noise or
vibration.
12.7 Check the slack on the bearings of the return and pressure
rollers
1. Replace the return or pressure roller if the slack on the bearings is above the
specifications of the supplier.
12.8 Check the slack on the roller bearings
1. Replace a roller if the slack is above the specifications of the supplier.
DANGER
Do not use any corrosive and inflammable solvents or cleaning agents on the
machine that contain TRI, PER, TETRA or FCHC. Read the instructions on the
packaging when use is made of chemical substances (cleaning agents).
WARNING
•
Electrical components should not make contact with water or other liquids.
•
Do not clean the machine with compressed air or water under high pres-
sure.
•
Avoid parts made of rubber or plastic, such as cables and gaskets, from
making contact with oil, solvents or other chemicals.