Speedkid 2020
Subject to change without notice. – 07|2020 –
17
Assembly
Danger!
The axle nut must be tightened in order to assure sufficient clamping force.
Therefore, observe the assembly instructions for the hub and the manufacturer’s
torque specifications when tightening the axle nut.
Caution!
Due to the construction of the coupler, slight wear and tear in the form of
scratches can occur at the connection between bicycle frame and coupler.
This is not a reason for a complaint.
Danger!
Do not use a washer or similar at the connection between the bicycle frame and
coupler because this could negatively affect the stability of the connection.
Tip!
The provided universal coupler is suitable for mounting on the most rear-wheel
models. If it does not fit your bicycle, find a suitable adapter and special couplers
in our manuals on the following website:
www.qeridoo.de/kupplungsleitfaden
Caution!
Do not use a tool which was previously in contact with conventional steel. Smallest
steel particles could be transferred that could lead to contact corrosion.
»
In the as-delivered state, the supplied coupler is connected to the tow bar:
»
Undo the cotter pin fastening and remove the coupler.
»
Then insert the retaining cotter pin onto the tow bar coupler pocket.
»
Prepare the bicycle for mounting the coupler by undoing the screw connection of the rear
wheel axle:
–
Quick-release axle: Open the bracket of the quick-release axle and unscrew the cap nut
on the other side of the rear wheel axle.
–
Full axle: Unscrew the nut on the left side of the
rear wheel axle.
»
Mount the coupler on the rear wheel axle:
–
Place the large hole of the coupler onto the left
side of the rear wheel axle so that the coupler is
facing outwards.
–
Screw on the dedicated nut and tighten it slightly.
–
Align the rear wheel so that it can turn freely.
–
Align the coupler so that it faces horizontally to
the rear.
»
Tighten the connection firmly in order to secure the
rear wheel:
–
Quick-release axle: Use the supplied quick release adapter. Tighten the cap nut until you
can close the clamping bracket with a little pressure.
–
Full axle: Observe the tightening torque instructions of the bicycle manufacturer.
