Speedkid 2020
Subject to change without notice. – 07|2020 –
15
Assembly
Inserting the pennant
Danger!
The pennant must always be mounted in Trailer mode. Otherwise the very low
Speedkid
is too easily not seen by other road users.
For safety reasons, we recommend putting the pennant into the pennant pouch so
that it is easily visible before every journey, including in Buggy or Walker mode.
»
Connect the two parts of the pennant pole using the
orange middle piece.
»
Fit the pennant on the left outside of the
Speedkid
:
–
Guide the pennant staff through the loop at the
top left on the cover.
–
Insert the end of the pennant staff into the
pennant pouch located below.
»
Unroll the pennant so that it can fly clearly visible on
the pennant staff.
Optional assembly steps
Installing the buggy wheel
You need the buggy wheel for Buggy and Walker mode. The buggy wheel is connected directly with
the wheel suspension attached to the frame and is mounted so that it can rotate through 360 °.
»
Lift the cabin at the front.
»
Place the buggy wheel into the wheel mount as far as
it will go, until it engages audibly with a clicking noise.
»
Check whether there is sufficient air in the buggy
wheel (maximum air pressure: 1.9 bar). If necessary,
use an air pump for car valves to top up with air.
Adjusting the buggy wheel
»
Set with the release button (unlock key)
and the
mode selector switch
in front of the suspension
the desired operating mode:
–
Buggy mode: Buggy wheel rotatable through 360 °.
–
Walker mode: Buggy wheel running straight.
–
Trailer mode: unfasten and pull out the buggy
wheel.
