14
– 06|2019 – Subject to change.
Kidgoo 2019
Assembly
f
Slide the leaf spring cover onto the slide holder as shown
in the picture.
f
Be sure that the fixing mechanism locks audibly.
f
Repeat the procedure on the other side of the trailer.
Installing the head protectors
The head protectors serve as additional side protection in case the trailer should tip over.
f
Slide the head protector onto the slide holder as shown in
the picture.
f
Be sure that the fixing mechanism locks audibly.
f
Repeat the procedure on the other side of the trailer.
Mounting the push handle
The push handle has multiple height settings and is used for pushing, pulling and manoeuvring your
Kidgoo
. And if it becomes necessary, it performs an important safety function as a impact protection.
The push handle is attached at the top of the cabin frame using 2 connecting screws:
f
Unfold the push handle completely. To do this, keep the light grey pushbuttons pressed on both
sides, see
„Adjusting the push handle“ on page 21
.
f
Use two hex keys to loosen and remove the two pre-as-
sembled screws.
f
Hook the upper loops of the canopy into the tube ends at
the cabin roof.
f
Insert the two ends of the push handle into the tube ends
at the cabin roof.
f
First, insert one part of the two-piece connecting screw
into the opening of the push handle and lock it with a hex
key.
f
Insert the second part of the connecting screw into the
opposite opening and tighten it firmly with the second
hex key.
f
Repeat the procedure on the other side.
Danger!
Make sure that the push handle is also mounted for every journey in Trailer mode. Only then
does the cabin have an impact protection.
