Rev: 01
P/N: 95343
Page | 20
3.5 PurgeScan® Logging and Setup
3.5.1 PurgeScan Logging Setup and Interval
PurgeScan Logging File Name
To set up the PurgeScan log, the user will go to the PurgeScan Menu, under the Settings menu. After menu has
been accessed a dialog box will appear prompting to name the new logging file. It is common to use the Well ID
and Date, but the file can be named anything seen fit. An example name will appear in the field; the user can
delete this and add the Well ID. There is also the option to select from existing file names, where the user can
select previous log files to appended new data to the file.
3.5.2 PurgeScan Logs
PurgeScan logs are the logs where the data and parameters set by the user are saved to.
3.5.3 Sensors and Parameters
Enable the desired parameters from the list shown by clicking the box to produce the check mark. Clicking on a
box with a check mark removes the check mark and disables that parameter. Only select parameters for sensors
that are installed. If a parameter is selected and the MP25 or MP25T does not have that sensor installed, the
data will not be accurate.
Measured parameters are Temperature, pH, Oxidation-reduction Potential (ORP), Specific Conductance (SpC),
and Dissolved Oxygen (DO) for the MP25. The MP25T adds turbidity measurement. Calculated parameters are
Total Dissolved Solids (TDS), Salinity and DO percent saturation (% Sat). Where a parameter can be displayed in
more than one range of units (e.g, Specific Conductance in microsiemens/centimeter (µS/cm) or
millisiemens/centimeter (mS/cm), select the desired range.
The order of the enabled parameters in this list is the order in which the parameters will appear in your Data
Display Home Page, the order in which they will appear in Logging files, and the order in which they will appear
in Snapshot files. The user can change the parameter order by clicking on the parameter name and then moving
the highlighted name up or down by clicking on the up- and down-arrows at the bottom of the screen.
