q-Tech QSW-9010, Cli Configuration Manual

Page: 10 / 101

User Manual
1. GPON properties 10
www.qtech.ru
1.4.1. Serial Port
Please set the baud rate as 115200.
Please do not choose “RTS/CTS” and “XON/XOFF”, see the figure below:
Figure 1-1 Serial Port
1.4.2. Telnet
1.4.2.1. Out band Configuration
QSW-9010 has two out-band management ports, the first (the upside one) IP address is
192.168.100.2, which can not be changed, while the second (the downside one) IP is 192.168.1.32.
In addition, OLT can be managed by Telenet after in-band IP configuration.

In-band management system connects to the IP network by using the service channel
(Uplink port), which is usually used for real network deployment.

Out-band management system use MGMT port, the management channel will be
independent from the service channels, which is usually used for local management and
maintenance.
1.4.2.2. In-band management configuration
The information will be sent by service channel under in-band management mode. It is more flexible
and cost-effective, but not convenient for maintenance.
Table 1-1 Configuration Data