INSTALLATION INSTRUCTIONS
for PYROCLASSIC FIRES LTD
100mm SLOPING CEILING ECO FLUE KIT
THIS FLUE KIT HAS BEEN MANUFACTURED IN ACCORDANCE WITH AS/NZS 2918:2001.
WARNING
: TO ENSURE SAFETY THIS FLUE KIT MUST BE INSTALLED AS OUTLINED IN THESE INSTRUCTIONS.
WOOD FIRE AND FLUE PIPE CLEARANCES FROM COMBUSTIBLE WALLS MUST BE IN ACCORDANCE WITH
WOOD FIRE MANUFACTURERS SPECIFICATIONS AND AS/NZS 2918:2001.
CAUTION
: MIXING FLUE SYSTEM COMPONENTS FROM DIFFERENT SOURCES OR MODIFYING THE
DIMENSIONAL SPECIFICATION OF COMPONENTS MAY RESULT IN HAZARDOUS CONDITIONS. WHERE SUCH
ACTION IS CONSIDERED, THE MANUFACTURER SHOULD BE CONSULTED IN THE FIRST INSTANCE.
CAUTION
: IT IS THE RESPONSIBILITY OF THE INSTALLER TO ENSURE THAT THE INSTALLATION OF THIS FLUE
KIT COMPLIES WITH AS/NZS 2918:2001. THE APPLIANCE MANUFACTURERS SPECIFICATIONS FOR FLUE PIPE
SHIELD AND CEILING PLATE AND THAT THE RELEVANT BUILDING CODES ARE ADHERED TO.
To install this flue design the installer should be familiar with the installation of flue kits for standard ceilings
and have competent carpentry and roofing skills. They should also be aware of the 4.6 metre height
requirements of AS/NZS 2918:2001 and minimum height requirements as per figure 4.9 (Diagram C).
This Sloping Ceiling kit is designed for installations into ceilings with slopes of up to 45 degrees.
All instructions refer to Diagrams C and D.
The flue pipes are tapered to fit the upper section inside the lower one.
Our Full Flow Cowl (ie. no cap), prevents dripping of condensed acids down the chimney.
The flue discharges some 18 litres of water as vapour for each 30kg of dry wood burned.
Do not put a cap on the Pyroclassic Flue System.