Pyramid Innovation P21001-E, Operator'S Manual

Page: 7 / 71


Pyramid Innovation Ltd 12-08-2014
7
PI003-D100 v7
Safety Information
Introduction
Pyramid Innovation Ltd products are designed for convenient and reliable service; however, incorrect actions
by a user may damage the equipment, or cause a hazard to health.
The following sections contain important information for the safe setup and use of the instrument.
All users must read and understand the following sections before using the instrument.
General Safety
This instrument, as supplied, conforms with IEC61010-1 issue 2010; however, the addition of
chemical introduces potential hazards.
As with all scientific equipment, due care and good laboratory practice must be employed when
dealing with these chemicals, and consideration must be given to the potential for hazard when
dealing with particular chemicals.
Do not remove any panels or covers. The instrument does not have any user serviceable parts.
The instrument must be properly connected to a good earth (ground) via the Mains input supply.
The instrument is only to be connected to the mains power supply using the supplied power adaptor
and detachable mains lead. For replacement power adaptor or mains lead see the Consumables and
accessories list or ask you distributor.
Position the instrument such that it is possible to interrupt the Mains supply at the source by removing
the plug from the socket.
If the equipment is used in a manner not specified by Pyramid Innovation, the protection offered by
the equipment may be impaired.
In compliance with statutory requirements all our equipment is designed to accepted standards of
safety. Its use does not entail any hazard if operated in accordance with the instructions given in the
documentation. However, the following safety precautions must be obeyed:
•
All users must have read and understood the Operator Guide and these safety instructions;
and only operate the unit in accordance with the instructions
• Potentially lethal voltages above 100V AC or 50V DC are present inside the power adaptor.
Do not remove any access covers or tamper with the mains lead
•
It is important that normal standards of safety and good laboratory practices are employed
• Always use common sense when operating the instrument
•
Any problems and queries should be referred to your Pyramid Innovation supplier
• Correct maintenance procedures are essential for consistent performance. It is recommended
that a Maintenance Contract is taken out with our Service Department
• Any maintenance or service work required may only be carried out by trained personnel
• The instrument should be placed on a suitable level surface and not in direct sunlight
•
Use only factory approved accessories or replacement parts with this instrument
•
Only use cleaning agents recommended in the Operator Guide