- 6 -
GENERAL OPERATION
Turn Unit On/Off
•
Press the power ( ) /
MODE
button on the front panel to turn on the unit, and long press it again to
turn off the unit.
•
Press the power ( ) button on the remote control to turn the unit on or off.
Adjust Volume (VOL)
Rotate the
VOL
knob on the front panel or press the
VOL+
/
VOL-
button on the remote control to
increase or decrease the volume level.
Adjust Menu Options (SEL)
•
Press the
SEL
button on the front panel or on the remote control repeatedly to cycle through the following
adjustable audio functions: BASS, TREBLE, BALANCE, FADER, EQ FLAT/POP/ROCK/CLASS/OFF,
LOUD ON/OFF, DX/LOC, STEREO/MONO and VOLUME.
•
Rotate the
VOL
knob on the front panel or press the
VOL+
/
VOL-
button on the remote
control to adjust the selected item.
- BASS/TREBLE:-07,-06, ~, -01,00,+01,~, +06,+07
- BALANCE:L07,L06,~, L01, 00, R01,~,R06,R07
- FADER:R07,R06~,R01,00,F01,~,F06,F07
- EQ(Equalizer) Setting: OFF, FLAT, POP, ROCK, CLASS
- Loudness: LOUD ON/OFF
- DX/LOCAL: Enables or disables the local broadcast mode (LOCAL).
- Stereo/Mono: Switches between MONO and STEREO reception mode for radio frequencies.
- Volume level:00,01,~,40
•
Press and hold the
SEL
button on the front panel or press the
SEL
/
ENTER
button on the remote
control to access these additional functions: VOL(LAS/ADJ), AREA EU/US, CLOCK 24/12, BEEP
ON/OFF.
- VOL(LAS/ADJ):This option allows you to preset a volume level as the power-on memory
volume level.
- VOL LAST: In this mode, the unit switches on at the actual volume it had when it was last
switched off.
- VOL ADJ: In this mode, the unit power on at the actual volume that you preset a constant
switch-on volume level.
Press the SEL button to enter the constant switch-on volume adjusting mode and
the “A-VOL XX” will be shown on the LCD display.
Then you can adjust a constant switch-on volume level by rotating the VOL knob.
- AREA EU/US: This car radio is equipped the Europe / USA frequency.
Rotate the volume knob to switch between USA and Europe frequency.
The system will change the frequency setting in about 3 seconds.
- CLOCK 24/12:
This unit is equipped with two types of clock display formats, 24 and 12 hours.
Rotate the volume knob to choose 24 hours format or 12 hours format.
- BEEP ON/OFF:
Enables or disables the “BEEP” signal to confirm use.
•
Rotate the
VOL
knob on the front panel or press the
VOL+
/
VOL-
button on the remote
control to adjust the selected item.
Set the Clock (CLK)
1. To display clock time, press the
CLK
button.
2. To set clock time, press and hold the
CLK
button and the hour will flash.
