40 Watt Guitar Amplifier
8'' Speaker with Volume, Bass, Treble,
Gain and Digital Reverb Controls
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
Before going any further, make sure that your amplifier is compatible
with your mains electricity supply.
1. Ensure that the
MAINS
(power) switch is set to the
OFF
position.
2. Connect the supplied mains (power) lead into the mains electricity supply.
3. Ensure that the
VOLUME
controls are set to zero.
4. Plug your guitar into an
INPUT
jack socket.
5. Turn the front panel
MAINS
switch to the
ON
position.
6. Turn the
VOLUME
up to your preferred level and your amplifier is ready to play.
Function
1-2.
INPUT:
Input for your guitar. Use a good quality guitar cable (i.e. one that’s
screened/shielded) to help prevent noise, interference and unwanted feedback.
3.
GAIN:
This control sets the operating level of the pre-amp. Simply turn up the Gain
control until the required amount of distortion is achieved.
4.
SELECT:
Select the drive channel or normal channel.
5.
TREBLE:
Increasing the Treble will make your sounds brighter and more cutting,
turning it down will decrease your tone’s edge and make it sound softer as a result.
6.
MIDDLE:
Adjusts the sound level of middle-frequency range.
7.
BASS:
Adjusts the sound level of the low-frequency range.
8.
LENGTH:
This equalization controls reverb length
9.
DEPTH:
This equalization controls reverb depth
10.
VOLUME:
This is the overall level control for the normal channel.
www.PyleUSA.com
1 2
3
5
4
6
7
8
9 10 11 12
13
