PPDLSM
METAL DISTORTION
CONTROLS
1. The LEVEL control adjusts the output level.
2. The LOW control allows you to boost/cut the low-frequency
range.
3. The HIGH control allows you to boost/cut the high-f
range.
requency
able.
. The 1/4 TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9v power supply (not included). The Battery Compartment is
his effects pedal has no on/off switch. As soon as you insert the jack into the Input connector, the
PECIFICATIONS
TS Impedance 500k
e Center
A
x 2.12”H
AFETY INSTRUCTIONS
stall near heat sources. Use only authorized attachments / accessories.
www.pyle udio.com
4. The DIST control adjusts the amount of distortion effect and
the length of the resulting sustain. High distortion settings will
allow for extremely long sustaining tones.
5. The ON/BATT LED illuminates when the effect is activated.
It also serves as a battery level indicator.
6. Use the Footswitch to activate/deactivate the effect.
7. Use this 1/4 TS IN connector to plug in the instrument c
8
located underneath the pedal cover. To install or replace the 9v battery, press the hinges with a pen
and remove the pedal cover.
T
pedal will turn on. When not in use, remove the jack from the input connector to save the batteries.
S
Input Connector: 1/4
Output Connector: 1/4 TS Impedance 1k
Power Supply: 9V, 100mA DC regulated
Power Connector: 2mm DC Jack, Negativ
Battery: 9v Type 6LR61
Power Consumption: 30m
Dimensions: 4.9”D x 2.76”W
Weight approx. 0.33kg (0.73lbs)
S
Do not use near water, or in
Do not service product yourself. Contact our service department with any questions or to schedule
repair service.
a
