PWR Bikes Superbolt, Manual

Page: 10 / 16

10
PWR Electric Balance Bike Manual
TABLE OF CONTENTS
5. TROUBLESHOOTING GUIDE
A fully charged battery must be installed prior to performing any
troubleshooting and must ONLY be performed by an adult.
IF YOU
ARE NOT CONFIDENT IN EXECUTING TECHNICAL PROCESSES,
PLEASE CONSULT A BICYCLE MECHANIC. DISCONTINUE
USE WHILE TROUBLESHOOTING AND NORMAL FUNCTION IS
RESTORED!
PROBLEM POSSIBLE CAUSE SOLUTION
Electric balance
bike does not
work
Battery not
installed or fully
seated
Verify a fully charged battery
is installed. Push battery until
release buttons click
Battery not fully
charged
Verify the battery is fully
charged
Did not press
and hold button
for 3 seconds
Press and hold the power
switch for 3 seconds
PRODUCT PARTS: Keep your electric balance bike running for years
with genuine PWR parts. Visit www.PWRbike.com for information
on spare part availability. (Illustrations may not reflect exact
appearance of actual product, specifications subject to change
without notice.)
FUSE REPLACEMENT
1. Remove the left side cover. [Figure 8]
2. Locate the inline fuse holder and remove the cover to access
the fuse. [Figure 9]
3. Remove the damaged fuse and replace with a new one. Replace
the cover on the inline fuse holder and ensure the power cable
is routed neatly. [Figure 10]
4. Reinstall the left side cover and tighten the screws. [Figure 11]
FIGURE 8 FIGURE 9
Troubleshooting Guide
FIGURE 10 FIGURE 11
1. TROUBLESHOOTING PROBLEMS
Follow steps to find resolution. Contact PWR if problems persist or
you need assistance
PROBLEM POSSIBLE CAUSE SOLUTION
Balance
bike will not
power on
Switch not
pressed correctly
1. Review Owner’s Manual.
2. Attempt to start again.
Battery not
installed correctly
1. Remove and reinstall.
2. Check installation is
secure.
Wire connections
loose
1. Check wire connections.
2. Reconnect as needed.
Check battery
function
1. Check battery indicators.
2. Check if battery is charged.
3. Remove and reinstall.
4. Check installation is
secure.
Fuse blown
1. See technical process
“Replacing the Fuse.”
2. If problems persist,
contact PWR.
Note: If no “Beep” after
powering on could indicate
faulty control board, contact
PWR.
PROBLEM POSSIBLE CAUSE SOLUTION
“Beep”
continuous
after
powering on
Check battery
function
1. Check battery indicators.
2. Check if battery is charged.
3. Remove and reinstall.
4. Check installation is secure.
5. If problems persist, contact
PWR.
“Beep”
sound while
in use
Check battery
function
1. Check battery indicators.
2. Check if battery is charged.
3. Remove and reinstall battery.
4. Check installation is secure.
5. If problems persist, contact
PWR.
Stops
operating
during use
Check for
Improper Use
1. Exceeding weight limit
2. Starting on incline without
assistance
3. Obstructions in moving parts
Battery not
installed
correctly
1. Remove and reinstall.
2. Check installation is secure.
Wire
connections
loose
1. Check wire connections.
2. Reconnect as needed.
Check battery
function
1. Check battery indicators.
2. Check if battery is charged.
3. Remove and reinstall.
4. Check installation is secure.
Fuse blown
1. See technical process
“Replacing the Fuse.”
2. If problems persist, contact
PWR.