RD100 & RD200 PVA
Revision A (2016)
24 of 35
Digital Pressure Switch
On the digital pressure switch, the set point is shown as the number at the bottom of
the screen in smaller text size and the actual pressure is shown as the larger, top
number. There are two set points a high and a low.
To set the low set point:
1.
Push the blue mode button on the digital pressure switch.
2.
The set point “Hi” or “Lo” will flash briefly. Push the blue mode button until you
see “Lo”.
Figure 21: Low Set Point
3.
The word will go out of view and the value for that set point will be shown. Use
the up and down arrow buttons to adjust the set point to the necessary value.
To set the high set point:
4.
Push the blue mode button on the digital pressure switch.
5.
The set point “Hi” or “Lo” will flash briefly. Push the blue mode button until you
see “Hi”.
6.
The word will go out of view and the value for that set point will be shown. Use
the up and down arrow buttons to adjust the set point to the necessary value.
Figure 22: High Set Point
