BI2000 Board Inverter Manual
Revision F
/
February 2020
Page 29 of 37
Board Thickness Adjustment
This procedure will adjust the distance between the chains, there should be a 1mm gap
between the board and the chain. The gap between the upper and lower conveyor chain is
adjustable from 0.28” to 0.154” to reduce product movement during rotation. To adjust the
opening size, perform the procedure below.
Note: Make sure you know the current orientation of the roll cage so that you can
adjust the chain correctly.
Note: Adjust both sides of the conveyer evenly.
1.
Engage the
Emergency
Stop
button.
2.
Turn the main air pressure to “
Off
”.
3.
Loosen the four shoulder bolts at the end of the turnbuckle. There are four bolts at
each end of the conveyor and each end is adjusted independently.
Figure 26: Loosen the Bolts Shown
4.
Use a ½” wrench to turn the turnbuckle.
Figure 27: Turnbuckle Adjustment
5.
With the shoulder bolts loose, rotate the turnbuckle clockwise to increase the gap or
counterclockwise to reduce the gap.
