MOLLE Panels Instruction Guide
1
2
Unscrew and remove the 4 tie-down plates using a T30 Torx driver. Place the side mounting
brackets behind the tie down plates, then fasten to the bed re-using factory hardware. (NOTE: for
the 6.5ft Super Duty molle the front side plate bracket is larger than the one for the rear).
Unscrew and remove the 2 rear tie-down hooks using a T30 Torx driver. Place the rear brackets
behind the rear tie-down hooks, then fasten to the bed re-using factory hardware.
INSTALLATION INSTRUCTIONS
1951XXI
3
4
Unscrew and remove the 2 front tie-down
hooks using a T30 Torx driver. Place the front
lower brackets behind the front tie-down
hooks, then fasten to the bed re-using factory
hardware.
Loosely assemble one 5/16 bolt and one well nut
to each of the two front upper brackets. Then
insert the well nuts into the front slots located
toward the top of each bed side. Tighten the
bolt using a 3/16 hex key until the well nut is
snug in the slot, but do not overtighten! (Note:
These top brackets can be slightly adjusted
forward and back within the slot to get the
desired rack positioned.)
Front Upper Bracket
Front Lower Bracket
5
Loosely assemble a jam nut onto each of the
supplied rubber feet, then screw the feet into
the nutserts located on the bottom flange of
the front molle plate.
Rear Bracket
Side Brackets
