OWNER’S MANUAL —
Please read before using this equipment.
BIG BUTTON PHONE WITH
SPEAKERPHONE AND CALLER ID
PT8433
IMPORTANT SAFETY INSTRUCTIONS
When using your telephone equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock and injury to
persons, including the following:
1. Do not use this product near water, for example, near a bath tub, wash
bowl, kitchen sink or laundry tub, in a wet basement or near a swimming
pool.
2. Avoid using a telephone (other than a cordless type) during an electrical
storm. There may be a remote risk of electric shock from lightning.
3. Do not use the telephone to report a gas leak in the vicinity of the leak.
4. Use only the power cord and batteries indicated in this manual. Do not
dispose of batteries in a fire. They may explode. Check with local codes
for possible special disposal instructions.
SAVE THESE INSTRUCTIONS!
INDUSTRY CANADA CS03 STATEMENT
This product meets the applicable Industry Canada technical specifications.
This is confirmed by the registration number. The abbreviation, IC before
the registration number signifies that registration was performed based on
a Declaration of Conformity indicating that Industry Canada technical
specifications were met. It does not imply that Industry Canada approved
the equipment.
Before installing this equipment, users should ensure that it is permissible
to be connected to the facilities of the local telecommunications company.
The equipment must also be installed using an acceptable method of
connections. The customer should be aware that compliance with the
above conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or alterations
made by the user of this equipment, or equipment malfunctions, may give
the telecommunications company cause to request the user to disconnect
the equipment.
WARNING!
Users should not attempt to make such connections themselves,
but should contact the appropriate electric inspection authority,or an
electrician, as appropriate.
CAUTION:
The Ringer Equivalence Number (REN) assigned to each
terminal device provides an indication of the maximum number of terminals
allowed to be connected to a telephone interface. The termination on an
interface may consist of any combination of devices subject only to the
requirement that the sum of the Ringer Equivalence Numbers of all the
devices does not exceed 5. An alternative indication of the REN is the
Load Number (LN); this number should be divided by 20 to approximate
the equivalent REN. The REN Number of this unit is indicated on the
bottom of your telephone.
INDUSTRY CANADA RSS 210 NOTICE:
CLASS B LIMITS WITH INTERFERENCE
STATEMENT
This equipment complies with the limits of a Class B digital device as
specified in Industry Canada Regulations. These limits provide reasonable
protection against radio and TV interference in residential areas. However,
this device might cause radio or TV interference even when it is operating
properly.
Operation is subject to the following two conditions: (1) This device may
not cause interference, and (2) this device must accept any interference
including interference that may cause undesired operation of the device.
To eliminate the interference, you can try one or more of the following:
• Reorient or relocate the receiving antenna.
• Move your device away from the receiver.
• Connect your device to an outlet that is on a different electrical circuit
from the receiver.
This digital apparatus does not exceed the Class B limits for radio noise
emissions from digital apparatus.
BATTERY NOTES
Dispose of old battery promptly and properly.
Do not burn or bury batteries.
Use only fresh batteries of the required size and recommended type.
Do not mix old and new batteries, different types of batteries (standard,
alkaline, or rechargeable), or rechargeable batteries of different capacities.
If you do not plan to use the phone for two weeks or longer, remove the
batteries. Batteries can leak chemicals that can destroy electronic parts.
You must install the batteries before connecting the telephone to the
walljack. If no batteries are installed, the telephone and Caller ID
will not work.
3
4
5
6
7
8
10
12
15
14
16
17
18
19
20
21
22
23
24
25
9
11
2
1
1. Telephone Jack
2. Power Jack
3. Display
4. New Call LED
5. Up Button
6. Down Button
7. Ringer Hi/Lo/Off Switch
8. Memory Button
9. Emergency (Ambulance)
Button
10. Tone/Pulse Switch
11. Store Button
12. Flash Button
13. Speaker Volume Control
14. Mute Button
15. Key Pad
16. Redial Button
17. Visual Ringer LED
18. Speakerphone Button
19. Call Back Button
20. Hook Switch
21. Delete Button
22. Handset Guide
23. Emergency (Fire) Button
24. Emergency (Police) Button
25. Receiver Volume Control
13
