background image

128-9319

1 of 4

3 Channel Remote Car Starter

FEATURES :

2 Three Button Programmable RF Transmitters
Three Channel Receiver (capable of accepting 4 transmitters)

External Superheterodyne Receiver Antenna w/PushButton Switch & LED

Keyless Entry Outputs 
Trunk Release Output
On-Board Start Relay
On-Board Accessory Relay
On-Board Ignition 1 Relay
On-Board Ignition 2 Relay
Ignition 2 Relay Selectable On or Off During Cranking
On-Board Parking Light Relay
Ignition 3 / Shock By-Pass / GM VAT Output (relay required)
Tach Signal Learning Circuit
Two ( + ) and Two ( - ) Safety Shutdown Circuits

Alarm By-Pass Output

Accessory Outputs (Pulse Before & After Start, During Crank & After 

Shut Down)
Selectable Steady or Flashing Parking Lights for Run Indication 
Selectable 5, 10, 15, 20, 45, 60 Minute Run Time
Selectable Door Lock Output Pulse Timing

Car Finder Mode

PATENTED:  www.voxxintl.com/company/patents

Model PRO9556E

Owner’s Manual

Summary of Contents for PRO9556E

Page 1: ...Ignition 2 Relay Ignition 2 Relay Selectable On or Off During Cranking On Board Parking Light Relay Ignition 3 Shock By Pass GM VAT Output relay required Tach Signal Learning Circuit Two and Two Safety Shutdown Circuits Alarm By Pass Output Accessory Outputs Pulse Before After Start During Crank After Shut Down Selectable Steady or Flashing Parking Lights for Run Indication Selectable 5 10 15 20 4...

Page 2: ...mitter for 4 seconds or until the electric trunk of your vehicle opens REMOTE STARTING THE VEHICLE This unit will not start the vehicle if any one of the following situations exist The vehicle s hood lid is opened The gear shift selector is not in Park The brake pedal is depressed The safety control switch is in the Off position 1 To start the vehicle press and release the Key Trunk button two tim...

Page 3: ...tion programs the Lock Unlock Start Trunk and Option 1 buttons which are typical for most systems For additional channel programming beyond the 1 option button you can use any unused button or combination of buttons not in use In other words to access option channel 5 6 7 you would do the following From step 3 above a Press and Release the Valet Programming button 4 additional times to get to chan...

Page 4: ... case from the rear 3 Slide the CR2032 battery out from under the battery clip and dispose of properly 4 Install the new battery with the side facing up away from the circuit board 5 Close the case and reassemble in reverse of disassembly FUNCTION SETTING CHART To be completed by installer Run Time _____Min Door Lock Timer ______Sec Lights Pulse Steady 2014 Voxx Electronics Corp 150 Marcus Blvd Ha...

Reviews: