PURSUIT 2670 CUDDY CONSOLE, Owner'S Manual

Page: 65 / 137

2670 CUDDY CONSOLE
Chapter 10:
INTERIOR EQUIPMENT
10.1 Marine Head System (Electric)
This system is provided as standard equipment. The flush water
is supplied by a thru hull fitting, located behind the starboard
access hatch in the center console storage compartment, and a
raw water line. Before using, open the inlet valve on the head and
pump to wet the inside of the bowl. After use, close the valve and
pump to discharge the waste to the holding tank or overboard.
Waste is pumped into the holding tank where it remains until it
is pumped out by a waste dumping station or the optional
overboard macerator discharge system.
IN MANY AREAS IT IS ILLEGAL TO FLUSH HEAD WASTE DIRECTLY OVER-
BOARD. VIOLATION OF THESE POLLUTION LAWS CAN RESULT IN FINES OR
IMPRISONMENT. ALWAYS KNOW THE LAW FOR THE AREAS IN WHICH YOU
BOAT. NEVER DUMP HEAD OR HOLDING TANK WASTE OVERBOARD ILLE-
GALLY.
Holding Tank and Macerator Discharge Pump
The holding tank is located in the battery storage
compartment at the rear of the V-berth. When the tank
is full it must either be pumped out by an approved
waste dumping station through the waste deck fitting
or be pumped overboard with the macerator discharge
pump, when legal to do so.
To operate the macerator discharge pump, open the discharge ball valve located behind the port
access hatch in the center console storage compartment. Then activate the macerator switch,
located on the DC panel below the helm, until the tank is emptied. Turn the switch to “OFF” and
close the discharge ball valve when pumping is complete.
10-1
Marine Head
DC Panel and Macerator Switch