PURSUIT 2670 CUDDY CONSOLE, Owner'S Manual

Page: 38 / 137

2670 CUDDY CONSOLE
Trim Tab Switches
Located in the helm switch panel. These switches control the trim tab planes located on the
transom of the boat. They are protected by the tabs breaker located in the helm 12-volt breaker
panel. Please refer to the Helm Control Systems chapter for detailed information on the
operation of the trim tab controls.
Accessory Switch
This switch is supplied to protect additional equipment that may have been installed by Pursuit
or your Pursuit dealer. If no accessories are activated by this switch it remains wired in the panel
in reserve.
12-Volt Receptacle
Provides electrical current for portable 12-volt equipment.
Additional Accessory Switch Panels
Additional switch panels are located in various locations in the cockpit and helm area of the boat.
Most of these panels are equipped with one switch and one circuit breaker. The following are
descriptions of additional panels that may be on your Pursuit and the accessories they control:
Baitwell
This switch activates the baitwell light and circulating pump that supplies water to the baitwell.
The pump is protected by a circuit breaker in the panel and an automatically resetting breaker in
the pump motor.
Washdown Pump
Located under the gunwale in the cockpit. This switch activates the raw water washdown pump.
The pump is the pressure demand type and is protected by a circuit breaker in the panel and an
automatically resetting breaker in the pump motor.
Note: Please refer to the Raw Water chapter for more information on the baitwell and
washdown systems.
Engine Trim and Tilt Switches
These switches are typically installed in the engine controls on the helm. They control the
trimming and tilting of the engines. Please refer to the Helm Control Systems chapter and the
engine owner's manual for information regarding the proper use of the tilt and trim switches.
Windlass
Located in the helm. This switch controls the optional windlass which is mounted to the deck
directly above the rope locker. It is protected by a circuit breaker, of the type and rating
recommended by the windlass manufacturer, that is located on the TABS unit.
4-4