Puretec UF10 Series, User Manual, Page: 9 / 20

9 Copyright © Puretec Pty Ltd 2020 UF Series User Guide
5. Install the bypass (if purchased) or a manual bypass (add diagram for manual bypass).
6. Install a valve before and after system if no bypass is installed.
7. It is recommended to install pressure gauges before and after the system to monitor
pressure loss (not supplied).
8. Connect the system to the main plumbing. Do not solder brass adaptors while they are
inserted into the valve.
Apply plumbing tape to the fittings as required. Connect the pipework to the valve, refer to page
6 for identification of the inlet/outlet.
FOLLOW LOCAL PLUMBING CODES – Installation should be carried out by a qualified plumber.
9. Connect the Drain Line.
Locate the drain tube assembly. Remove the red clip from the drain port, refer to page 6 for
identification of the drain port. Insert the drain tube assembly, and reinsert the red clip.
Connect extra tube (tubing not supplied) onto the 5/8” drain line from the valve to the drain.
The length of drain line should be as short as possible.
Ensure the drain line is not kinked. The line must not travel more than 2.4 m up from the
valve, otherwise increase the diameter of the drain line. Connect drain to sewer or stormwater
according to local guidelines. DO NOT connect to a septic tank. Ensure drain line has an adequate
air gap of 2 times the pipe diameter or 25 mm, whichever is larger.
10. Connect the TankSafe Suction Line.
Locate the TankSafe suction assembly. Insert the assembly into the shut off valve and then
connect the cap to a 2 L bottle of TankSafe (TankSafe not supplied). Ensure the TankSafe suction
line is shut-off at the valve (see Page 6 for identification).
11. Ensure Flush Valve is closed. Connect flush valve to drain with 3/4” pipework (pipework not
supplied).
Installation is now complete.