Puretec UF10 Series, User Manual, Page: 3 / 20

3 Copyright © Puretec Pty Ltd 2020 UF Series User Guide
Puretec Customer Service
Thank you for purchasing a Puretec Ultrafiltration System. Your system is a proven
performer manufactured from only quality materials and components. It will give years
of reliability and trouble free operation if maintained properly.
This user guide is designed for Puretec UF Systems. Be careful to ensure the information
and illustration is applicable to your particular unit.
Caution: Do not use with water that is microbiologically unsafe or without
adequate disinfection before or after the system.
Puretec systems are designed to run economically for many years, this is dependent on
the initial installation and periodic maintenance.
Flush system for 5 minutes or more after any period of non-use more than 2
weeks. Backwash system after and period of non-use more than 1 month.
Note: For point of entry installations an approved dual check backflow prevention device
must be installed. When line pressure exceeds 690kPa a pressure limiting valve must be
installed.
Note: Additional parts are required for installation, refer to 'Installation' section
Installation Note: A water filter system/tap, like any product, has a limited life and may
eventually fail. Also sometimes failure happens early due to unforeseen circumstances.
To avoid possible property damage, this product should be regularly examined for
leakage and/or deterioration and replaced when necessary. A drain pan, plumbed to an
appropriate drain or outfitted with a leak detector, should be used in those applications
where any leakage could cause property damage, and/or the water supply should be
turned off if no one is home/present.
INSTALLATION SHOULD BE COMPLETED BY QUALIFIED TRADESPEOPLE.
FAULTY OPERATION DUE TO UNQUALIFIED PERSONS WILL RESULT IN VOIDED
WARRANTY COVERAGE.