User Manual
IPAV Pro Series
42
5.6
HDMI Audio Routing Tab
IPAV Pro routes HDMI audio separately from the video signal, e. g. for routing the
audio to additional or different Receivers (RX).
Exception:
In "Genlock Mode", the HDMI audio follows the video when one or more Receivers
(RX) are joined with one Transmitter (TX) from any of the video routing tabs ("Video
Wall", etc.). Simply put: When an RX device is in "Genlock Mode", it receives both the
HDMI video and the HDMI audio signals from a single source. The same also applies
for all video switching modes, when no separate HDMI audio stream is enabled.
To route the HDMI audio signal, select the tab "HDMI AUDIO ROUTING".
All RX devices are listed in the top half of the Receiver (RX) section. Similarly, all TX
devices are listed in the bottom half in the Transmitter (TX) section.
First, verify if appropriate TX and RX units are joined together to route their HDMI
audio signal:
1)
Verify, if the Receiver (RX) is currently joined to an appropriate Transmitter (TX).
a)
Click on the RX to highlight the TX it is joined to in blue.
b)
Selecting the respective TX will highlight all the receivers joined to the same
TX.
2)
If the respective Transmitter (TX) is currently not joined to the Receiver (RX),
proceed to join them:
a)
In the Transmitter (TX) section, select a TX by left-clicking on its associated
active tile.
b)
Drag and drop the TX tile over the RX tile to join them.
c)
TX and RX are now joined together.
d)
Repeat above steps, if additional receivers are to be joined to the same TX.
