06
07
3.3
“Coil Temp 000°C”:
Used to display the current
temperature of the coil.When it is below zero,
the “-” symbol is displayed in front. “-” is not
required on zero.
3.4
Wifi hotspot:
factory setting is “0FF”,
press > to enable wifi hotspot and switch
ON/OFF.The device can transmit data and receive
APP commands.The icon flickers when connected
on the main interface. After successful connection, .
the icon displays normally.
3.5.1
3.5.2
The power down time is adjusted according
to “>” and the power down time increases
from 3 to 20 minutes (3-5-10-15-20), which
is the so-called stop time of the fan after
shutdown, in order to better drain the
water.Factory set for 3 minutes.(the other
state of the fan is still 15 seconds.)
The screen displays when you
press shut down:
Indicates: the fan is closed after
a few minutes,and the standby
page UNIT OFF is displayed after
the fan is closed.
3.6
3.7
“Temp Units °F/°C”:
Used for temperature
scale switching. Press the “>” button to
switch°F / °C,after switch symbol of
corresponding parts is also changing.
“MOISTURE CONTENT UNITS”:
It is used to switch the unit of GPP
value with moisture content.
Press > to switch the Ib or Kg, after
switch symbol of corresponding
parts is also changing.
4
5
3.8
“Humidistat Setpoint 00%”:
Used for setting
dehumidificationmode humidity.Press “>” to set the
humidity. The adjustment range of humidity setting is
between 25 and 80%.Each key rises or falls 5%, which
can be recycled.
When the setting is completed,do not operate for 5 seconds
and begin to take effect.(Otherwise, the compressor will be
shut down immediately after it is below ambient humidity at the time of setting.) Humidity
below 25 percents "CO" mode recyclable.' The main interface displays the set parameters.
MAIN INTERFACE FROSTING STATUS DISPLAY:
The machine will display this after defrost when running
When the machine is running normally,
“Deffrost SHUTDOWN IN 06:00”will
occurs in the interface after defrosting.
It's defrost countdown use seconds as
units. This screen displays only 3
seconds. Displays the previous
interface and status after restoration.lf
it is the home screen,the frost icon
will flash.
When the user is operating in the submenu,
the machine is in the frosting state .At this
point, the frosting interface displays 3
seconds, and returns to the submenu
program in the background countdown.
When the user returns to the main interface
without any operation, the frosting state
is displayed inthe main interface in the way
of icon flicker.
COM PRESSOR ON WAITING INTERFACE DISPLAY
Compressor protection time not shown:
“Compressor ready IN 03:00” indicates :
That the
interface will be displayed when the compression is
in a protected state. (including power-on and shutdown,
the humidity rises immediately after the arrival of LO
HI, and the shutdown resumesimmediately after the
emergence of LO HI). Displays the countdown in seconds.
If the above situation does not occur within 3 minutes, it is
not shown.
PureAiro
WCD 85C
