*** Note
-
The faucet requires a 36mm hole.***
1.
Connect the 3 supplied hoses to the bottom of the faucet ensuring the hot and cold hoses are in the
correct position (Figure 2). Do not use mechanical means to tighten, only hand tighten (Figure 3).
2.
Attach the stabilizing screw into the remaining port on the bottom of the faucet.
3.
Place the escutcheon then rubber washer over the hoses up to the base of the faucet (Figure 1).
4.
Feed the hoses through the hole in the sink and mount faucet in desired location, ensuring that the
escutcheon and rubber washer are in position (Figure 1).
5.
From underneath the sink, place the rubber washer and then metal washer over the stabilizing screw
and lock into position with the locking nut, ensuring that the locking nut is secured well to prevent the
faucet from moving when it is in use (Figure 1).
6.
Connect the John Guest ¼” tube to the filtered water hose of the faucet using the supplied insert,
olive and compression nut (Figure 4).
7.
Connect the hot and cold water hoses to the mains supply.
TRI
-
FLOW FAUCET (FAUCET6)
