Re
vi
si
o
n 1
.0
Product Manual
ITSCAM FF 600
17
www.pumatronix.com
Figure 9 - RJ-45 connector standard EIA/TIA-568ª
ETH2 Ethernet network interface: The ITSCAM FF 600 second network interface is
disabled in the standard equipment setup.
Antenna Connection
The images captured by ITSCAM FF 600 may present the geolocation, made available by the GPS integrated
with the equipment. The Wi-Fi, 4G and 3G signals can also be amplified using external antenna, with SMA
type connector (male connector, i.e., with center pin).
Connectors for Wi-Fi, 4G and 3G antennas signals are available on the back panel of ITSCAM 600 image
capture and processing device. The screen printing on the equipment back panel assists in identifying
connectors for the antennas:
Figure 10 - SMA connectors for the antennas in the ITSCAM device 600
1
Wi-Fi Antenna
3
MOV Antenna
2
GPS Antenna
4
4G/3G Antenna
Antennas for 4G and 3G
For 4G/LTE and 3G/GSM (Quad Band) cellular mobile communications, ITSCAM FF 600 has two antennas
with the same minimum gain specifications of 2 dBi and the frequency range: 850 MHz, 900 MHz, 1.8 GHz,
1.9 GHz, and 2.1 GHz. If the customer needs to use antennas or signal amplifiers for a longer range, the
following are the main specifications that should be considered:
•
Frequency range:
850 MHz, 900 MHz, 1.8 GHz, 1.9 GHz, 2.1 GHz, 1.71~2.17 GHz;
•
Typical signal gain for the respective frequency ranges: 1.42 dBi, 1.91 dBi, 2.51 dBi, 3.23 dBi, 2.89
dBi.
GPS Antenna
