105
Name
Enter the name to help identify the controller when it connects to Fluent.
Location
Enter the location to help identify the controller when it connects to Fluent.
Global Units
Select the units to be used for cable length and wire gauge settings, metric or Imperial.
Temperature Units
Select between Fahrenheit and Celsius.
Alarm Delay
Enter how much time to wait after powering up the controller before alarm conditions are
considered valid.
HVAC Modes
Enable HVAC Modes for cooling tower and boiler applications where the relay control
modes for Biocide timer, Bleed and Feed, Bleed then Feed, and Intermittent Sampling
are required. Disable HVAC Modes if these control modes are not necessary and a more
generic timer control mode will replace the Biocide timer.
Language
Select the language the software will use.
5.4.2
Security Settings
Controller Log Out
When Security is Enabled, and after the password has been entered, the controller requires
immediate use of a password to calibrate or change settings. Once finished making changes,
log out to prevent unauthorized changes by someone else. If not manually logged out, the
controller will automatically log out after 10 minutes of inactivity.
Security
Select Enable to require a password in order to calibrate or change settings, or Disable to
allow calibration and set point changes without a password. In order to enable security, the
default password must be entered first, then touch Enabled, then touch the Confirm icon.
Local Password
Used to change the touchscreen password needed for full configuration capability if security
has been enabled. The default local password is 5555. This can and should be changed using
this menu if Security is enabled.
5.4.3
Ethernet Settings
Will not appear if a WiFi-Only type WiFi card is installed.
Ethernet Status
Select Enabled or Disabled
Gateway Connection
Only appears if a Dual WiFi/Ethernet type WiFi card is installed. Select which connec-
tion, Ethernet or WiFi, will provide the Gateway function. This means that all external
Internet connections such as Fluent or emails will default to using this connection.
Note that If the selected connection is no longer available, the controller will switch to
DHCP Setting
Select Enabled to get an IP address from the LAN or Disabled to use a fixed IP address.
Controller IP Address
Enter the default IP address to use if a network is not available or if DHCP is disabled.
Network Netmask
Enter the default netmask to use if a network is not available or if DHCP is disabled.
Network Gateway
Enter the default gateway address to use if a network is not available or if DHCP is disabled.
DNS Server
Enter the default DNS server IP address to use if DHCP is disabled.
Webserver
Enter the Webserver menu to manage the webserver encryption
Webserver Mode
Select between HTTPS (recommended, web pages will be encrypted), HTTP (web
pages will not be encrypted) and Disabled (no web pages will be served).
SSL Certificate
Only appears if Webserver Mode is HTTPS.
Select between Default Cert (which uses a self-signed certificate) or Upload PEM
which provides a way to enter a certificate of the network IT administrator’s
choice.
